Fujitsu
MYRICA-V32-1
(Our category: lcd)
Replacement Remote Control. No setup is required.
These compatible remote controls look very different to the original one that came with your device. The layout of the functions is different.
The majority of the functions are obvious, but a keymap is printed on the receipt in case you need it.
We do use the same casings on a number of different models and just use a different chip inside set with the codes for your item. This results in zero waste. We use all the parts we buy and don't stock too many or too few of any type.
All you need to do is to insert two batteries and it is ready to use. Long battery life; remote goes into very low power sleep mode when not in use.
This remote works on the Fujitsu MYRICA-V32-1 only.
You will be able to access the important setup menus and also;
blue - hold for subp
expand (text size)
freeze
pip - hold for swap
picture
page
page
swap
sleep - timer used to switch off at night
Fujitsu MYRICA-V32-1
Remote Control : Fujitsu myrica-v32-1
£11.99
Notes on the functions:
pip - hold for swap,picture in picture - hold down to swap the pictures over
>,go right in menu / guide
exit,go back or get out of the menu
v,go down in on screen menu
^,up for menu item selection - may also do channel+